You are here

Solvent Hood - J21 - J23 Headway Spinner

Equipment Type: 
III-V Lithography
Equipment Area: 
North Cleanroom
Equipment Location: 
1.728
Description: 

Solvent hood with spinner to apply photoresist.
Do NOT remove Labware from this tool!

Compatible Materials: 
No Restrictions
Procedures: 

1. Log on to the tool using the LabAccess terminal.
2. Line the spinner basin with clean room wipes. (NOTE: Since these wipes are “trash” you can do your part to keep the lithography bay tidy by using “used” wipes that are laying around instead of getting new wipes from the dispenser.) 3-4 wipes should be enough to cover the sides of the basin – use more if you are coating a lot of wafers.
3. Choose the correct wafer chuck size and push it onto the spindle.
4. Turn the spinner ‘power’ on.
5. Set the correct spin time on the thumbwheels.
6. To put photo resist (PR) on a wafer:
a. Place your wafer centered on the chuck.
b. Turn the vacuum on by pushing the ‘vacuum’ button – make sure your wafer is held securely by gently nudging the side with tweezers.
c. Put the photo resist (AZ5209, etc) in the center of your wafer please do not waste the photo resist as it is very expensive!)
d. Start spinning the photo resist on. If something goes wrong during the spinning (eg. wafer falls off the chuck), you can stop the spin.
f. The vacuum will be turned-off after spin. Remove your wafer from the chuck.
7. If you are not pleased with the photo resist coat (eg. Not uniformly coated, or particles in the PR) you can remove the photo resist by rinsing your wafer in acetone, then methanol, then isopropanol, and finally DI water. Make sure to dispose of any acetone, methanol, or isopropanol in the waste containers located above the blue solvent cabinet – please do NOT dump them down the sink! Also, dispose of any solvent-soaked wipes in the red waste can for solvents.
8. When you’re finished coating your wafers with photo resist (PR), please place the PR-soaked wipes into a ziplock bag (located on the wall next to the hood), seal the bag closed, and place in the red solvent waste can. Please make sure that the bag is properly sealed because these PR fumes are harmful when inhaled!
9. Take the wafer chuck off the spindle after coating the wafers.
10. Please clean up any PR drops, etc…that may have been spilled in the hood area using acetone and wipes, and dispose of properly in the red solvent waste can.
11. Log off of the tool using the LabAccess terminal.
NOTES:
Keep the spinner hood CLEAN, and some solvents are toxic!!! It is not only important to your own, but also to all other people in the cleanroom. DO NOT drain any solvent through the sink. Put the waste solvents, such as Acetone, Methanol, IPA, developer, etc., back to the appropriate waste bottle.